Table of Contents
Advertisement
7.
Close the computer
cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
8. Connect your computer and devices to electrical outlets, and turn them on.
9.
Enter the system setup program
10. Properly dispose of the old battery. See "Battery Disposal" in the safety instructions in your Owner's Manual.
Drive Door
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual.
Removing the Drive Door
1. Open the drive door.
2. Unsnap the top bracket hinge and pull the top of the drive door outward, away from the computer.
and restore the settings you recorded in step 1.
Advertisement
Table of Contents
