Onkyo TX-NR929 Owner's Manual page 29

1
Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV
receiver is connected.
2 Set the speaker setup microphone at the Main
Listening Position , and connect it to the
SETUP MIC jack.
SETUP MIC jack
Speaker setup microphone
The speaker setting menu appears.
Note
• The on-screen menus appear only on a TV that is
connected to HDMI OUT MAIN. If your TV is
connected to other video outputs, use the AV
receiver's display when changing settings.
3 When you've finished making the settings,
press ENTER.
MultEQ XT32: Auto Setup
Speakers Type(Front)
Powered Zone 2
Powered Zone 3
11ch Playback
Subwoofer
Perform the "2. Speaker Setup" according to your
speaker configuration:
– Speakers Type(Front) (➔ page
– Powered Zone 2 (➔ page 65)
– Powered Zone 3 (➔ page 65)
– 11ch Playback (➔ page 65)
– Subwoofer (➔ page 65)
If you use a powered subwoofer(s), go to step 4.
If not, go to step 5.
If "Speakers Type(Front)" is set to "Digital
Crossover", a confirmation screen appears.
Select "Next" to display the screen for Digital
Processing Crossover Network
Continue with the settings.
4
Adjust the subwoofer volume level to 75 dB,
and then press ENTER.
Test tones are played through the subwoofer.
Use the volume control on the subwoofer.
Note
• If your subwoofer does not have a volume control,
disregard the displayed level and press ENTER to
proceed to the next step.
• If you set the subwoofer's volume control to its
maximum and the level displayed is lower than 75 dB,
leave the subwoofer's volume control at its maximum
and press ENTER to proceed to the next step.
5
Use / to select "Audyssey Quick Start" or
"Audyssey MultEQ XT32 Full Calibration",
and then press ENTER.
6 Press ENTER.
Audyssey MultEQ
Speaker Setup starts.
Test tones are played through each speaker as
Audyssey MultEQ XT32 Room Correction and
AUDYSSEY
Speaker Setup runs. This process takes a few
Normal
minutes. Please refrain from talking during
No
No
measurements and do not stand between
No
Yes
speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey MultEQ XT32 Room Correction
65)
and Speaker Setup, unless you want to cancel
the setup.
If you select "Audyssey Quick Start", you will go
to step 9.
(➔ page 68).
® XT32 Room Correction and
En-29
Turning On & Basic Operations
7
Place the speaker setup microphone at the
next position, and then press ENTER.
Audyssey MultEQ XT32 performs more
measurements. This takes a few minutes.
8
When prompted, repeat step 7.
9
Use / to select an option, and then press
ENTER.
MultEQ XT32: Auto Setup
-- Review Speaker Configuration --
Subwoofer Yes
Front 100Hz
Center 40Hz
Surround 100Hz
Front Wide None
Front High 100Hz
Surround Back 120Hz
Surround Back Ch 2ch
Save
Cancel
The options are:
Save:
Save the calculated settings and exit
Audyssey MultEQ XT32 Room Correction
and Speaker Setup.
Cancel:
Cancel Audyssey MultEQ XT32 Room
Correction and Speaker Setup.
Tip
• You can view the calculated settings for the speaker
configuration, speaker distances, and speaker levels
by using / .
AUDYSSEY