Volume Level; Hdmi Audio - Marantz SR6008 Owner's Manual

Contents
2 Lch Level
Adjust the left channel output level.
–12dB – +12dB (Default : 0dB)
2 Rch Level
Adjust the right channel output level.
–12dB – +12dB (Default : 0dB)
2 Channel
Set the signal output from multi-zone.
Stereo (Default) : Select stereo output.
Mono : Select monaural output.

2 HDMI Audio

Selects the audio signal format for playing an HDMI source in ZONE2.
Through (Default) : The HDMI audio signal is passed through the AV
receiver to the device in ZONE2.
PCM : The HDMI audio signal is converted to PCM format so you
can listen to HDMI sound from the ZONE2 pre out or ZONE2
assigned speakers.
Front panel Display
Connections Playback
Rear panel
Settings

2 Volume Level

Set the volume output level.
Variable (Default) : Volume adjustment is enabled by main unit and
remote control unit.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
2 Volume Limit
Make a setting for maximum volume.
60 (–20dB) / 70 (–10dB) / 80 (0dB) (Default : 70 (–10dB))
Off : Do not set a maximum volume.
2 Power On Volume
Define the volume setting that is active when the power is turned on.
Last (Default) : Use the memorized setting from the last session.
Mute : Always mute when power is turned on.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
2 Mute Level
Set the amount of attenuation when muting is on.
Full (Default) : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
%
• This can be set when "Volume Level" is set to "Variable".
184
Remote
Tips Appendix
Index