Operations - Onkyo TX-930 Instruction Manual

Operations
To listen to your favorite Source
(3) SPEAKERS and HEADPHONES
(6) VOLUME
4.) MAIN POWER
(2) SYSTEM POWER
(TX-930)
(2) STAND-BY/ON
(TX-910)
@) Press the MAIN POWER switch to turn on the power. Press this
switch to switch the on/off status of the power supply.
(2) Press this button to turn on power and the AC outlets on the rear
panel (TX-930 only) when the unit is in the standby mode. Power
can also be turned on by using the remote control power button.
NOTE:
When you turn off the power by pressing the MAIN POWER switch,
you cannot turn on again using the remote control.
When you turn off the power by pressing the SYSTEM POWER
button (TX-930 only) or the STAND-BY/ON button (TX-910 only),
you can use these buttons to turn on the power again, or you can
use the remote control to turn on the power.
(3) Select the desired pair of speakers by depressing the correspond-
ing speaker selector switch.
@ This unit can drive two pairs of speakers in pairs (A or B) or fours
(A+B). To listen to both speaker systems at once, depress both
speaker selector switches.
® Stereo headphones with a standard binaural plug can be
connected here.
@ Press one of the desired Input Selector Button (CD, PHONO, FM,
AM, TAPE-1/VIDEQ).
Make sure that the connections between the input Sources are
correct.
® The button pressed is shown in Display. For FM or AM, the band
and the frequency are shown in Display.
® Confirm that the TAPE-2 MONITOR indicator is off when a
source other than the TAPE-2 MONITOR has been selected.
Also check the audio muting is off.
® Start play of the selected input source.
@ Follow the operating instructions of that unit.
@ If FM or AM is selected, please refer to the section "Tuner
Reception'.
© Adjust the Volume Control knob to the appropriate level.
@ Turn clockwise to increase the volume level. The volume canbe
adjusted manually and by the remote control transmitter's
Volume UP/DOWN button.
~10—
Direc
(7) Tone Controls
(4) Input Selector Buttons
(5) Starting Source Selected at (4)
@ Adjust the Tone Controls to obtain the desired tone setting.
@ Bass Control Knob (BASS)
Adjust to strengthen or weaken bass response.
m Treble Control Knob (TREBLE)
Adjust to strengthen or weaken treble response.
M@ Balance Control Knob (BALANCE)
Use this control to adjust the relative volume levels of the left
and right speaker systems.
M@ Loudness Control Switch (LOUDNESS)
When listening at low volume levels, depress this switch to
boost the very high and very low frequencies to provide a more
natural sound.
NOTE:
This function works when an Onkyo cassette tape deck or CD
player with the (RI mark is connected to a TX-930/910 with an
fR21 remote control cabie.
Just by directly operating the desired component (compact disc player,
or tape deck), the TX-930/910's input selector automatically switches
to that component. The component that was being used stops, and the
desired component starts operation.
Therefore, it is not necessary to switch the TX-930/910's input selector
when changing listening sources.
Example
When the compact disc player's play button ts pressed, the TX-930/
910's input selector will switch automatically to "CD." If the current
listening source was a tape deck, tape playback will stop and the
compact disc player will start playing.
NOTE:
| The direct function feature does not apply to turntable.