Normal Led Flash Pattern; Connecting To The Local Network - TRENDnet TW100-W2 User Manual

Nway web cruiser

Hide thumbs Also See for TW100-W2:

Table of Contents

lated COM port will light. If no data is being transmitted, the

COM LEDs will be off.

Normal LED Flash Pattern

Immediately after power-up, all four of the LEDs should display

steady green for several seconds. Then both COM LEDs should

flash simultaneously three times. This sequence of flashes should

be followed by first COM1 flashing once and then COM2 flashing

once, repeated three times in succession. If as problem with the

device is detected during this time, the LED flashes will display an

error pattern (see Appendix A: Troubleshooting for more informa-

tion on POST error indications). If no errors are detected, the

internet server will begin operating normally.

The internet server includes one RJ-45 NWay LAN port. To

connect the device to your LAN, use a standard Category 3, 4,

5 UTP, or STP twisted-pair cable to link the device to an

Ethernet or Fast Ethernet hub or switch.

Cable length limits must conform to Ethernet and Fast

Ethernet wiring rules.

Ethernet cable segments can be a

maximum of 100 meters. Fast Ethernet wiring rules also limit

the maximum length of cabling segments to 100 meters.

Once the internet server is physically connected to a local net-

work and you have used the IS Admin software included to

assign an IP address to the device (or simply reconfigured your

PC's IP address, subnet mask and gateway to match the default

settings of the internet server), you may configure other pa-

rameter variables from your network station using Telnet or a

web browser.

Installation

Table of Contents