Wi-Fi Protected Setup (Wps) - TRENDnet TEW-800MB User Manual

TRENDnet User's Guide
3. Click OK and wait while changes are being applied. Setup is complete. Place
the TEW-800MB in your desired location. Please refer to the
wireless connectivity" section on page 18 for your location placement.
After the connection between the TEW-800MB and your router is successful,
the IP address of the TEW-800MB will change to a different IP from the default,
192.168.10.110. To find out the IP assigned to the TEW-800MB from your
router, please check the DHCP client (device) list on your router and then type
in the assigned IP of the media bridge from your router in the browser to
access to the management interface of the media bridge. You may type in the
http://tew-800mb in your browser to access to the management interface of
the media bridge.
© Copyright 2013 TRENDnet. All Rights Reserved.

Wi-Fi Protected Setup (WPS)

"Steps to improve
1. Power up the TEW-800MB (On/Off power switch, EU only); wait until the
2. The power button will start blinking. Installation is complete when the power
power LED on the front of the unit lights up.
Press the WPS button on your router for 5 sec, then the WPS button on the
TEW-800MB for another 5 sec.
LED turns solid green. Note: With the WPS installation method, the TEW-
800MB adopts your router's password settings and wireless encryption.
In WPS mode, the TEW-800MB may connect to your router on the default
2.4GHz band. Please refer to the Manual setting of the Basic Wireless Setting
section for the 5GHz band choice.
TEW-800MB
10