Frigidaire FFHB2740PE Use And Care Manual page 12

DOOR REMOVAL INSTRUCTIONS
Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left sides (two screws on each side).
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw

NOTE
Do not remove center screw from freezer
drawer. This is a factory adjustment.
Installing Freezer Drawer
1 With lower slides pulled out, hang drawer
onto slide brackets ensuring pins on each
side are fully inserted into slots on each side.
Drawer
Assembly
Pin
Slot
2 Reinstall four drawer screws (two per
side), tighten down, and close drawer (C).
Install Screws
(2) Each Side
12
Do Not Remove
Other Screws
Fully Extend
Drawer Slides
Cabinet
Do Not Remove
Other Screws
CAUTION
Drawer is heavy. Use caution when lifting.
3 Lift drawer up and out to remove.
3 Check gasket seal around top, bottom,
and sides of freezer drawer.
4 If gasket is not sealed, open drawer and
slightly loosen four drawer screws (two on
each side) to allow drawer to rotate.
5 Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by
the sides in the center (B). Be careful not
to rotate the drawer.
Push
Against
Freezer
Drawer
A
6 Tighten four drawer screws.
7 Recheck gasket seal.
8 Install the toe grille by fitting into place.
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Grab Drawer
At Center
From Both
Sides Then
Pull Drawer
Out
B