Door Removal Instructions; Getting Through Narrow Spaces - Frigidaire FFHB2740PE Use And Care Manual

DOOR REMOVAL INSTRUCTIONS

Getting through narrow spaces

If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is
unplugged from the wall outlet.
2 Open the freezer drawer and remove the
toe grille (see "Installation" section).
3 Remove any food from the door shelves
and close the doors.
To remove the top hinge covers:
1 Remove the two screws from each cover
over the top door hinges.
2 Lift inside edge of hinge cover and tilt
back.
Front
Cover Screw
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
Front
Rear
Cover Screw
Cover
Screw
Ground
Top
Screw
Hinge

NOTE
DO NOT remove the ground screw from hinge.
10
To remove the refrigerator doors:
1 Trace lightly around the door's top hinges
2 Disconnect the harness by grasping both
Rear
Cover
Screw
Ground
Screw
Top
Hinge
Water
3 Detach the water tube from the connector
Line
Top Hinge
Cover
Hinge
Screws

Two Wire
Cables
Use care while pulling the water tube from
the unit to be sure that you do not kink the
Leave
tube.
Hinge
With
Door
with a pencil. This makes reinstallation easier.
sides of the connector firmly, depress the
latch, and pull apart. Remove the two
screws from the top hinge. Lift the door
off of the bottom hinge and set it aside.
located behind the refrigerator and pull
the tube back out to the front of the unit.
The connector releases when you press
inward on the outer sleeve while pushing
the tube toward the connector then while
continuing to hold in the sleeve, pull the
tube away.
NOTE