Akai PDP42Z5TA - 42" Plasma TV User Manual page 14

Note:
Pressing CH +/- button on the front panel can turn on the TV set from
standby mode.
Insertion of Batteries:
- Turn the remote control upside down, press and slide off the battery cover.
- Insert two 1.5V (AAA) batteries into the compartment, take care to observe
the and markings indicated inside.
- Replace the cover and slide in reverse until the lock snaps.
Range of Remote Control
- Ensure the remote control is pointed
towards the remote control window on
the display unit.
- No obstacles should be placed between
the remote control and the remote
control window.
- The effective receiving range for the
signal is within 5-8 meters from the
front of the remote control window, and
30° to the left or right side and 20°
above or below the control window.
Care For Remote Control
- Avoid spilling liquids on the remote.
- Avoid dropping or otherwise jarring the remote.
- Always store the remote control at dry and normal room temperature place.
- If the remote is not performing satisfactorily, replace the batteries.
The batteries should be replaced after one year.
- If the remote control will be idled for a long time (over 1 month) take out the
batteries to avoid leakage from the batteries.
- Clean up the entire remote control especially the battery compartment if any
leakage is found.
- Do not mix both new and used batteries together. This will help avoid battery
leakage.
14
Sketch map
20°