Table of Contents
Advertisement
Other Settings
Settings Common to the Entire
Drum Kit
From this display, you can set the parameters applied to the
entire sound of the current Drum Kit.
5 1
1 Volume
Determines the volume of the entire Drum Kit.
Range
0 – 127
B Tempo
Determines the tempo value called up when you select the
current Drum Kit. When "off" is selected, the tempo value is
maintained when you select the current Drum Kit.
Range
off, 30 – 300
C RevSend (Reverb Send)
Determines the Reverb depth applied to the Drum Kit. This
parameter offsets the same parameter for each of the Drum
Voices assigned to the current Drum Kit.
Range
0 – 127
D ChoSend (Chorus Send)
Determines the Chorus depth applied to the Drum Kit. This
parameter offsets the same parameter for each of the Drum
Voices assigned to the current Drum Kit.
Range
0 – 127
E TrigSetupLink (Trigger setup link)
Use this parameter to specify the trigger setup to be used
when the current kit is selected. A trigger setup can be
assigned to each different drum kit. Select "off" if the cur-
rently selected drum kit does not need a special trigger setup.
Settings
off, PRE:01 – 09, USR:01 – 05
NOTE
• If TrigSetupLink is set to "off," the trigger setup selected on the Utility
mode will be loaded by default whenever the DTX900 is turned on.
(See page 125.) Following this, the trigger setup can be freely
changed in the Trigger Mode. (See page 108.)
[SF1] COMMON
2
4
3
Hi-Hat Controller Settings
From this display, you can set the parameters related to the
Hi-Hat Controller (Foot Controller) connected to the HI-
HAT jack (page 12).
1
1 Function
Determines the function assigned to the Hi-Hat Controller.
When "Hi-Hat" is selected, you can use the Hi-Hat Controller
normally for playing the hi-hat cymbal. When "MIDI" is
selected, you can generate MIDI messages by pressing the Hi-
Hat Controller according to the settings of the MIDI Ch
parameter and MIDI Type parameter described below.
Settings
HiHat, MIDI
B MIDI Ch
Determines the MIDI channel over which operating the Hi-
Hat Controller generates MIDI messages. This parameter is
available only when the Function parameter is set to MIDI.
Settings
1 – 16
C MIDI Type
Determines the type of MIDI messages generated by operat-
ing the Hi-Hat Controller. This parameter is available only
when the Function parameter is set to MIDI. "Ctl000" –
"Ctl119" represent Control Change messages, "AT" repre-
sents Aftertouch, "PB up" represents Pitch Bend upward
(when pressing) and "PB down" represents Pitch Bend down-
ward (when pressing).
Settings
Ctl000 – Ctl119, AT, PB up, PB down
Reference
Drum Kit Mode [DRUM KIT]
[F6] OTHER
[SF2] HH CTRL
3
2
DTX900 Owner's Manual
95
Advertisement
Table of Contents
