8.
Slide the TouchPad button board bracket (3) up and away from the top cover until the tabs (4) on
the front edge of the bracket disengage from the slots (5) on the top cover.
Reverse this procedure to install the TouchPad button board.
Solid-state drive
Description
160-GB solid-state drive for use on all computer models
32-GB mSATA solid-state drive for use only on computer models equipped with an Intel processor
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
d.
Top cover (see
Battery on page
45), and then remove the following components:
Hard drive on page
46)
Optical drive on page
Keyboard on page
57)
Top cover on page
61)
51)
Component replacement procedures
Spare part number
681997-001
682099-001
69