Install A New Dc Power Supply - Dell Force10 Z9000 Quick Start Manual

CAUTION: Remove the power cable from the modules prior to removing the
module itself. Power must not be connected prior to insertion in the chassis.
WARNING: Prevent exposure and contact with hazardous voltages. Do not
attempt to operate this system with the safety cover removed.
CAUTION: Be sure that the DC power source is turned OFF before attaching
the cables to the DC connectors on the Z9000.

Install a New DC Power Supply

The power supply modules should slide into the slots smoothly. Do not force a
module into a slot. This may damage the power supply or the Z9000 chassis.
PSU0
Fan Modules
PSU1
Securing
DC cable
Screw
connectors
Grab
Handle
Step Task
Take the power supply unit out of the shipping box.
1
Remove the small plastic cover over the DC cable connectors. Do not
2
throw the cover away; you will replace it when installation is complete.
Ensure that the DC power source is turned OFF.
3
Using the grab handle, slide the unit into the power supply bay.
4
Tighten the securing screw on the side of the PSU.
5
Attach power cables.
6
Replace the small plastic cover over the DC cable connectors.
7
Turn the DC power source ON.
8
12
Installing the Hardware