Table of Contents
Advertisement
Display assembly
Description
33.78 cm (13.3-in) WXGA Brightview display assembly for use in Compaq Presario CQ32–
branded computers
33.78 cm (13.3-in) WXGA Brightview display assembly for use in HP G32–branded computers
Before removing the display assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Disconnect the wireless antenna cables from the WLAN module (see
6.
Remove the following components:
a.
Optical drive (see
b.
WLAN module (see
c.
Top cover (see
d.
USB board
Remove the display assembly:
1.
Turn the computer display-side up, with the front toward you.
2.
Open the display as far as possible.
3.
Disconnect the display panel cable (1) from the system board.
4.
Remove the two Phillips PM2.5×8.0 screws (2) that secure the display assembly to the computer.
CAUTION:
steps. Failure to support the display assembly can result in damage to the assembly and other
components.
5.
Remove the wireless antenna cables (3) from the hole and clips built into the base enclosure.
Battery on page
Optical drive on page
WLAN module on page
Top cover on page
(USB board on page
Support the display assembly when removing the display screws in the following
41).
54)
46)
55)
61).
Component replacement procedures
Spare part number
608017-001
628920-001
WLAN module on page
46).
73
Advertisement
Table of Contents
