Execute Paper Feed Adjustment And Color Calibration - Canon imagePROGRAF iPF6450 Manual

6. EXECUTE PAPER FEED ADJUSTMENT AND COLOR CALIBRATION

Execute paper feed adjustment and color calibration on the paper you are using for printing, and
put the printer and paper into a state where calibration link is possible.
The time required for paper feed adjustment and color calibration is approximately 15 minutes for
each paper type.
Furthermore, refer to the following for details on the size and amount required.
When Using Rolls
When Using Sheets (only for
genuine Canon paper)
Paper feed adjustment and color calibration are executed by using the following procedure.
1. Load the paper to use for printing into the printer and set the paper type.
For genuine Canon paper, paper feed adjustment is not needed. Once the paper is loaded
and the paper type is set, perform the procedure from step 8.
2. On the Tab Selection screen of the printer control panel, press
Settings/Adj. tab (
An unused roll at least 254.0 mm (10.00 in) wide
(however, a roll at least 406.4 mm (16.00 in) wide depending
on the paper type)
One sheet of unused paper of at least A4/Letter size
(however, one sheet of unused paper of at least A2 size
depending on the paper type)
).
26
or to select