7.3 Use at PC-CAM mode
SET−UP
SET−UP
POSTVIEW ON
POSTVIEW
POWER SAVE
USB MODE
USB MODE
DATE/TIME
1. Slide the Power switch to the side to turn
the camera on.
2. Set the "USB MODE" setting in the
"SET–UP" menu to "PC CAM" (➡P.80, 81).
3. Slide the Power switch to the side to turn
the camera off.
✽ You should use the AC power adapter (sold separately)
when the camera is connected to your PC (➡P.95).
Loss of power during data transmission can prevent
successful data downloading.
OFF
PC CAM
SET
Camera
DC IN 5V
socket
Digital
(USB) socket
4. Switch your PC on.
5. Use the special USB cable to connect the
camera to your computer.
6. Switch the camera on.
If you are using a Windows PC, the driver
settings are automatically specified when
installation ends. Just wait a few moments.
Always use the prescribed procedure when
disconnecting or switching off the camera
(➡P.102).
✽ Take care to ensure that the special USB cable is
connected the correct way around and that the plugs
are pushed fully into the connection sockets.
(USB)socket
PC
7
99