Connecting At Pc-Camera Mode - FujiFilm FinePix 2600 Zoom Owner's Manual

CONNECTING AT PC-CAMERA MODE

1
1 0 2 0
1Open the lens cover.
2Slide the Power switch sideways to switch the
camera on.
3Set the "USB MODE" setting in the "SET–UP"
menu to "PC CAM" (➡P.58).
4Slide the Power switch sideways to switch the
camera off.
66
2
4 0
(USB)
socket
DC IN 3V
(USB)
socket
3 0
socket
Camera
1Switch your computer on.
2Use the special USB cable to connect the camera to
your computer.
3Switch the camera on.
If you are connecting your camera to a Windows PC
for the first time, the "Add New Hardware Wizard"
window opens and driver software installation
begins (➡Software Quick Start Guide booklet).
Always use the prescribed procedure when
disconnecting or switching off the camera (➡P.68).
G
!
You should use the AC power adapter when the camera
is connected to your computer (➡P.21). Loss of power
during data transmission can prevent successful data
downloading.
G
!
Ensure that you insert the USB cable plugs into the
correct sockets.
G
!
Push the cable plugs firmly into the connector sockets.
Camera Operation
PC
i The viewfinder lamp alternately blinks green
and orange while the camera is communicating
with your computer.
i The lens is fixed at the wide-angle zoom setting.
i "PC CAM" appears on the LCD monitor.
i Power Save/Auto Power Off does not function
when a USB connection is being used.
G
!
Do not close the lens cover while the camera and
PC are communicating. If you close the lens cover,
the " ¥ " warning is displayed and
communication is interrupted.
G
!
Do not disconnect the USB cable when the camera
is communicating with the computer. See P.68 for
information on the disconnection procedure.
Computer Operation
i FinePixViewer automatically starts up and the
Picture Hello window opens (Windows only).
✽ Screen for Windows 98 SE
i You can use software
such as VideoImpression
to view live images.
✽ Macintosh screen
If the above operations do not occur, you do not
have the required software programs or drivers
installed on your computer. Refer to the Software
Quick Start Guide booklet and complete the
required computer setup procedures. Then
reconnect the camera to your computer.
6
67