Power Control For Pc Source; Power Save; Setup - Sharp Aquos LC-30HV4M Operation Manual

Basic adjustment settings

Power Control for PC source

Power Control allows you to reduce display brightness
and save energy.

Power save

When set to "Save1", "Save2", or "Auto", power
consumption is reduced by decreasing backlight
brightness.
1
Press MENU and the PC MENU screen
displays.
2
Press c/d to select "Power Control".
• Power Control menu displays.
3
Press a/b to select "Power Save", and then
press ENTER.
PC MENU
Power Control
Power Save
Power Management
4
Press a/b to select the desired backlight
brightness, and then press ENTER.
PC MENU
Power Control
Power Save
Selected item
The screen darkens slightly to conserve
Save1
power consumption.
The screen darkens more significantly to
Save2
conserve power consumption.
Backlight brightness adjusts according to
Auto the ambient light of the room to conserve
power consumption.
NOTE
• When setting to "Auto", the OPC indicator lights up green,
senses the surrounding light and automatically adjusts the
backlight brightness. Make sure no object obstructs the
OPC sensor, which could affect its ability to sense
surrounding light.
• Power Save can be set differently for AV input mode and
PC input mode.

Setup

[Standard]
[Off]
Standard
Save1
Save2
Auto
Description
Power management
When set, the power will automatically shut down.
1
Press MENU and the PC MENU screen
displays.
2
Press c/d to select "Power Control".
• Power Control menu displays.
3
Press a/b to select "Power Management",
and then press ENTER.
PC MENU
Power Control
Power Save
Power Management
4
Press a/b to select "Mode1" or "Mode2",
and then press ENTER.
PC MENU
Power Control
Power Management
Selected item
• No power management
Off
• Factory preset value.
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the System stays off.
Mode1
• The System turns on again by pressing B
(STANDBY/ON) button on the Display or B
on the remote control unit. (See page 14.)
• If no signal inputs for 8 seconds, the power
shuts down.
Mode2
• When you start using the PC and the signal
inputs again, the System turns on.
Setup
[Standard]
[Off]
Off
Mode1
Mode2
Description
37