About The Liquid Crystal Display; Using The Arrow Keys; Adjusting The Beep Volume - Sharp FO-3800M Operation Manual

About the Liquid Crystal Display

About the Liquid Crystal Display About the Liquid Crystal Display About the Liquid Crystal Display About the Liquid Crystal Display
The machine is equipped with a two-line liquid crystal display (LCD) on the
operation panel for displaying various messages and settings during operation.
This LCD can display up to 20 characters on each line. When the machine is
idle, the LCD shows the date, time, and the stand-by memory available.
Example:
Note: Note: Note: Note: Note: means this machine is in the Reverse Sending mode. It appears
when LCD shows "STAND-BY" or "SEND READY".
6
The left and right arrow left and right arrow left and right arrow left and right arrow ( left and right arrow
are very useful for scrolling through the various function lists and settings.
Once you have pressed the FUNCTION
functions as desired. (See the Function mode at the top of the Quick Reference
Guide for the settings.) Pressing the ENTER
function. For many of the function lists, you can then use the arrow keys again
to scroll through the settings.
Adjust the volume of both key beeps and alarm beeps (emitted at the end of
transmission and reception) using the procedure below.
Factory setting: 3 (MEDIUM)
Step Step Step Step Step Press these keys Press these keys Press these keys Press these keys Press these keys
1 1 1 1 1
FUNCTION
2 2 2 2 2
3 3 3 3 3
4 4 4 4 4
ENTER
5 5 5 5 5
STOP
44 44 44 44 44
SUK 06 INITIAL LEO.p65

Using the Arrow Keys

Using the Arrow Keys Using the Arrow Keys
Using the Arrow Keys Using the Arrow Keys
) keys on the operation panel of the machine
FUNCTION FUNCTION FUNCTION key, you can scroll through the ten FUNCTION
Adjusting the Beep Adjusting the Beep V V V V V olume Adjusting the Beep
Adjusting the Beep Adjusting the Beep
GHI
JKL
or or or or or
STOP
INITIAL SETTINGS
44
ENTER key chooses the displayed ENTER ENTER ENTER
olume olume olume
olume
Comments Comments Comments Comments Comments
"OPTION SETTING" will
appear in the display.
"BEEP VOLUME" will
appear in the display.
Press the or
lower or raise the volume
to the desired level.
"STORED" will appear in
the display.
Press the ST STOP ST ST ST OP OP OP key twice OP
to exit.
17/04/00, 13:14
key to