(direct, indirect, special, consequential, or otherwise and whether or not arising from a negligent act or omission of VICTA), incurred or suffered by reason for the goods, their use, their design or any failure to deliver or delay in delivering them.
CONTENTS WARRANTY OWNER’S INFORMATION INTERNATIONAL PICTORIALS SAFE MOWING GUIDE STEPS TO FOLLOW ASSEMBLY OPERATION MAINTENANCE TROUBLE SHOOTING CHART performance. As you read this manual, the owner to make sure the unit is correctly as- OWNER’S INFORMATION compare the illustrations to the unit. Learn the sembled.
Safe Operation Practices for Ride–On Mowers. This cutting machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. General Operation and above, are involved in a large percent- 2.
SAFE MOWING GUIDE battery. Even small batteries have enough volt- age to cause an injury. Always be careful. Each person that operates power equipment must learn to use correct and safe mowing pro- The mower is designed to be operated by one cedures.
equipment and other property. need service, select an Authorized Service Cen- Select the maximum engine and ground speed ter for your mower. If you do the work on the that is right for the terrain and the height of the unit, follow the instructions in the Instruction grass.
the blade every two years. For you to have a good green lawn, follow the erated by hand and holds the engine speed con- mowing procedures below. Do not cut the grass stant until it is changed. The location of the too short.
ASSEMBLY Check The Tyres How To Charge The Battery (Figure 4) Check the air pressure in the tyres. Tyres with WARNING: When you charge the All fasteners are in the parts bag. Do not discard too much air pressure will cause the unit to ride battery, do not smoke.
OPERATION NOTE: If the engine stops when you en- 3. Move and latch the automatic drive discon- gage the blade(s), the seat switch is not nect (1) in the PUSH position (3). The activated. Make sure you sit in the middle transmission is now released and the unit NOTE: Illustrations and pictorials begin on of the seat.
4. Slowly push the speed control pedal forward 3. Move the throttle control to the FAST posi- dels have a separate choke knob. Pull the to the desired speed. tion. choke knob to the full CHOKE position. 4. Turn the ignition key to the START position. 4.
3. Check the fasteners. Make sure all fasteners cess rubber from a new mower drive belt. If WARNING: Always keep the nut (3) are tight. you need assistance, take the unit to an tight that holds the blade (1). A authorized service centre.
Page 16
7. If the belt still slips after the belt has been Check The Tyres WARNING: To prevent sparks, adjusted, then the motion drive belt is worn fasten the red cable to the positive Check the air pressure in the tyres. Tyres with or damaged and must be replaced.
8. Pull the mower housing away from the right NEW ZEALAND side of the unit. The replacement parts are shown either on the Sunbeam Victa Corporation LTD 9. To install the mower housing, reverse the back pages of this Instruction Book or in a sep- 1043 Tremaine Avenue above steps.
TROUBLE SHOOTING CHART 2. Adjust the throttle control. 5. Move the throttle control to the FAST posi- tion. 3. Clean the air filter. 6. Replace the spring for the blade idler. 4. Replace the fuel filter. PROBLEM: The engine will not start. 7.
MODEL 40564x88B (VRO 4015HX) REPAIR PARTS MOWER HOUSING 5 47 F–000741L...
Page 29
MODEL 40564x88B (VRO 4015HX) REPAIR PARTS MOWER HOUSING Description Part No. Description Part No. Pulley, Jackshaft 92851 Spring 166x42 Nut, Hex 15x121 Bracket, Right Suspension 94142E700 Belt, Mower Drive 37x62 Plate 91770E700 Pulley, Idler 690387 Nut, Flange 15x88 Nut, Flange...
Page 30
MODEL 40564x88B (VRO 4015HX) REPAIR PARTS ENGINE MOUNT F–000741L...
Page 31
MODEL 40564x88B (VRO 4015HX) REPAIR PARTS ENGINE MOUNT Description Part No. Fuel Cap 92317 Fuel Tank 94073 Hose Clamp 95197 Fuel Line 23717 Hose Clamp 95197 Screw 26x201 Plate, Engine 94006E700 Throttle Control 91989 Engine ––––– Bolt, Engine Mount 25x7...
Need help?
Do you have a question about the VRO 4015HX and is the answer not in the manual?
Questions and answers