Post Error Messages - NEC Express5800/120Rj-2 User Manual

5.
If you set a password using the BIOS setup utility, SETUP, the password entry screen
appears upon successful completion of POST.
Up to three password entries will be accepted. Three incorrect password entries disable
the server to boot. In such a case, turn off the power and wait about ten seconds before
turning on to boot the server.
IMPORTANT:
6.
The OS starts when POST completes.

POST Error Messages

When POST detects an error, it displays an error message on the display unit screen. See Chapter 8
for POST error codes.
IMPORTANT:
consulting with your service representative. Alarm messages are useful
information for maintenance.
Power Off
Follow the procedure below to power off the server. If the power cord of the server is connected to a
UPS, refer to the manual that comes with the UPS or the manual for the application that controls the
UPS.
IMPORTANT:
the server.
1.
Shut down the OS.
2.
Press the POWER switch on the front of the server.
The POWER LED goes off.
3.
Power off peripheral devices.
NOTE:
not select "Standby" in Windows shutdown menu.
Do not set a password before installing an OS.
Take a note on the messages displayed before
Always allow POST to complete before turning off
The standby feature of Windows Server is not available. Do
General Description 2-27