Error Messages - NEC Express5800/120Rj-2 User Manual

STATUS LED
Description
indication
On (green) The server is operating normally.
Flashing The server is operating with the
•
(green) memory or CPU in degraded
state.
An uncorrectable memory error
•
has often occurred.
Off The power is off.
POST is in progress.
A CPU error occurred. (IERR)
A CPU temperature alarm was
detected.
A timeout occurred when the time
set for the watchdog timer arrived.
A CPU bus error occurred.
A memory dump request is made.
On (amber) A temperature alarm was detected.
A voltage alarm was detected.
All the power supply units failed.
Flashing Either of the following was detected
(amber) in the redundant power
configuration:
AC power not supplied to one of
•
the two power supply units
Failure of one of the two power
•
supply units
A fan alarm was detected.
A temperature warning was
detected.
A voltage warning was detected
An error was detected on either of
the hard disk drives.
General Description 2-11
Procedure
–
Identify the device in degraded state
by using the BIOS setup utility
"SETUP," and replace it as soon as
possible.
–
Wait for a while. The STATUS LED
turns green when POST is completed.
Turn the power off and then turn it on.
If the POST screen displays an error
message, take notes of the message,
and contact your sales representative.
Wait until the memory dump is
completed.
Check if the internal fans are clean
and if the fan units are firmly
connected.
If the STATUS LED indication does not
change when the fans are normal,
contact your sales representative.
Contact your sales representative.
Connect the power cord to supply
power. If the power supply unit is
faulty, contact your service
representative.
Check if the fan units are firmly
connected.
If the STATUS LED indication does not
change when the fans are normal,
contact your sales representative.
Check if the internal fans are clean
and if the fan units are firmly
connected.
If the STATUS LED indication does not
change when the fans are normal,
contact your sales representative.
Contact your service representative.