Ricoh Type 2075 Operating Instructions Manual page 145

Messages/Second messages
Exceeded max. pages. Collate
is incomplete.
HDD has a problem.
Data storage error.
HDD is full.
dLower staple is almost
empty.
NV-RAM has a problem.
Output tray has been
changed.
Paper in staple tray. Open Fin-
isher Cover and remove paper.
Parallel I/F board has a prob-
lem.
Print overrun.
Problems with the wireless
board.
Problems with the wireless
card.
Punch has been cancelled.
Causes
The maximum number of pag-
es has been exceeded for colla-
tion.
An error has occurred in the
hard disk drive.
Locked Print was performed
without the hard disk installed,
or the hard disk is damaged.
The maximum hard disk area
size for form/font has been ex-
ceeded.
An HDD overflow error oc-
curred during Sample Print or
Locked Print.
There are only a few staples
left in the lower stapler.
An error has occurred in the
NV-RAM.
The output tray has been
changed because of the paper
size limitation of the selected
tray.
There is paper remaining in-
side the finisher.
An error has occurred in the
parallel interface board.
The image data has been
thinned out due to image com-
pression.
An error may have occurred in
the IEEE 802.11b interface unit.
An error may have occurred in
the IEEE 802.11b interface unit.
Punch has been cancelled.
Troubleshooting
Solutions
Turn off the main power
switch, and back on again. Re-
duce the number of pages to
be printed. If the message ap-
pears again, contact your sales
or service representative.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Contact your sales or service
representative.
Delete unused form / font
types.
Delete some stored files, or re-
duce the size of the file to be
downloaded.
Load more staples.
Turn off the main power switch,
and back on again. If the mes-
sage appears again, call your
sales or service representative.
Select the correct output tray.
Open the cover of the finisher,
and remove the paper.
Contact your sales or service
representative.
Increase memory capacity.
When installing a memory
module in the machine, con-
tact your sales or service rep-
resentative.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Check the paper feed direc-
tion, paper orientation, and
punch position.
8
139