Replacing Vacuum Bag And Filters - Riccar Sunburst Owner's Manual

Replacing the vacuum bag
Replacing the secondary filter
. Open the bag compartment and locate the
filter behind the vacuum bag. For better
access to the secondary filter, remove the
bag holder and bag.
2. Slide filter holder up and out.
3. Remove the used filter and replace it with
a new filter.
4. Slide the filter holder back in place and
replace the bag holder and bag.
Replacing the Performance HEPA filter
. Locate the Performance HEPA filter inside the
bag compartment near the door hinge.
2. Press the black tab to remove the used
filter and snap in a new filter. NOTE: The
Performance HEPA filter cannot be washed
and reused.

Replacing Vacuum Bag and Filters

Change the vacuum bag when the indicator is RED or
suction power is weak. The dust cover will not close
without a bag in the unit or if the bag is not properly
installed.
. Pull the bag holder straight out to access the bag.
2. Remove and discard the used bag. NOTE: The
Performance HEPA™ bag cannot be reused. Do not
throw away the bag holder.
3. Secure the new bag with the bag collar holder latch.
Slide the tab on the bag holder into the slot on the
front of the bag compartment.
5