Table of Contents
Advertisement
To arm using your remote
You can activate, or arm, the system by pressing
➤
second. When the system arms, you will hear a short siren sound, or chirp, and
the parking lights will flash once. If the vehicle's power door locks have been
connected to the system, the doors will lock.
To disarm using your remote
To disarm the system, press
➤
lights will flash twice. If power locks are connected to the system, the doors will
unlock. If the siren chirps either four or five times when disarming, see
Diagnostics section. This is called Tamper Alert.
Arming while driving
Press
➤
system will chirp once and then once more to indicate that the ignition is on.
Disarming without a transmitter
Turn on the ignition. Press the Valet button the programmed number of times
➤
within 15 seconds. After five seconds, the system will disarm. If it does not, you
may have waited too long. Turn the ignition off and on and try again.
To enter or exit Valet Mode
Turn ignition to RUN position, then turn to OFF position. Press and release
➤
the Valet button within 10 seconds. The status LED will light solid if you are
entering Valet Mode, and it will go out if you are exiting Valet Mode.
To activate Panic Mode
Press and hold
➤
To exit Panic Mode
Press
➤
To activate Silent Mode™
Press
➤
will be eliminated for that one operation only.
Location of Valet Button_______________________________
Number of Valet Button pulses for disarming_____________
© 2002 directed electronics, inc.
QUICK REFERENCE GUIDE
on your transmitter for two second while the vehicle is running. The
down for one second.
on the transmitter.
briefly before arming or disarming, and the confirmation chirp(s)
on your transmitter for one
. You will hear two chirps, and the parking
33
Hide quick links:
Advertisement
Table of Contents
