Quick Reference Guide - Python 700 Owner's Manual

To arm using your 2-way remote
You can activate, or arm, the system by pressing
➤
second. When the system arms, you will hear a short siren sound, or chirp, and
the parking lights will flash once. If the vehicle's power door locks have been
connected to the system, the doors will lock.
To disarm using your 2-way remote
To disarm the system, press
➤
lights will flash twice. If power locks are connected to the system, the doors will
unlock. If the siren chirps either four or five times when disarming, see
Diagnostics section. This is called Tamper Alert.
Arming while driving
Press on your remote for two second while the vehicle is running. The
➤
system will chirp once and then once more to indicate that the ignition is on.
Disarming without a 2-way remote
Turn on the ignition. Press and release the Valet
➤
number of times within 15 seconds. After five seconds, the system will disarm.
If it does not, you may have waited too long. Turn the ignition off and on and
try again.
To enter or exit Valet
Turn ignition to RUN position, then turn to OFF position. Press and release
➤
the Valet ® button within 10 seconds. The in-vehicle status LED will light solid
if you are entering Valet
Mode.
To activate Panic Mode
Press and hold
➤
To exit Panic Mode
➤ Press on the remote.
To activate Silent Mode™
Press briefly before arming or disarming, and the confirmation chirp(s)
➤
will be eliminated for that one operation only.
Location of Valet ®
Number of Valet Button pulses for disarming_____________
®
© 2005 directed electronics, inc.

QUICK REFERENCE GUIDE

. You will hear two chirps, and the parking
® Mode
Mode, and it will go out if you are exiting Valet
®
down for approximately two seconds.
Button_______________________________
on your remote for one
button the programmed
®
®
51