Vox Tonelab ST Owner's Manual page 30

If an effect is assigned to the expression pedal
The on/off switch LED of the assigned effect will blink,
and the program display will indicate "
If no function is assigned to the expression pedal
The program display will blink "
gram number will be displayed. In this case, use Quick
Assign to assign a function (p.24, "Assigning a function to
the expression pedal (Quick Assign)").
2.
Use the EDIT knob of the assigned effect (whose on/off
switch LED is blinking), or the GAIN control to specify the
minimum value.
HINT: You can skip this step, if you do not change the mini-
mum value.
3.
Press the EXP PARAM switch.
The program display will indicate "
4.
Use the EDIT knob you operated in step 2, or the GAIN
control to specify the maximum value.
HINT: You can skip this step, if you do not change the maxi-
mum value.
NOTE: If you decide to cancel the setting, press the EXIT/
TUNE switch.
26
".
" and then the pro-
".
5.
Press the EXP PARAM switch.
The program display will indicate "
second, and will then indicate the program number.
The QUICK ASSIGN LED will go dark.
NOTE: The assignment of a function to the expression pedal,
the minimum value, and the maximum value are specified
independently for each program.
6.
If desired, save these settings to the program.
For details on the procedure, refer to "Saving a program"
(p.12).
NOTE: The settings you made will return to their original
values if you switch programs or turn off the power before
saving.
Adjusting the minimum and maximum volume
If volume is assigned to the expression pedal, you can adjust the
minimum and maximum values as follows.
1.
Press the EXP PARAM switch.
The EXP LED and QUICK ASSIGN LED will blink, and
the program display will indicate "
2.
Use the VOLUME control of the AMP section to specify the
minimum value, and then press the EXP PARAM switch.
The minimum value will be specified, and the program
[DEC][INC] will indicate "
" for about one
".
".