Listening through a Receiver (Home theater)
You can listen to sound through a receiver instead of the TV speaker.
1
Press the MENU button to display the menu.
Press the ▲ or ▼ button to select Input, then press the ENTER button.
Press the ▲ or ▼ button to select Anynet+ (HDMI-CEC), then press the ENTER button.
Press the ▲ or ▼ button to select Receiver, then press the ENTER button.
4
Press the ◄ or ► button to select to On, then press the ENTER button.
Now you can listen to sound through the receiver.
5
Press the EXIT button to exit.
If your receiver supports audio only, it may not appear in the device list.
➢
➢
When listening through the receiver, there are restrictions for using the audio-related (MTS) menus.
➢
If there is a power interruption to the TV when the Receiver is set to On (by disconnecting the power cord or a power
failure), the TV Speaker may be set to Off when you turn the TV on again.
Check Points before Requesting Service
Symptom
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet + .
The Connecting to Anynet + device...
message appears on the screen.
The Anynet + device does not play.
The connected device is not
displayed.
The TV program cannot be
recorded.
Solution
■ C heck if the device is an Anynet + device. The Anynet + system supports Anynet + devices
only.
■ C onnect only one receiver (home theater).
■ C heck if the Anynet + device power cord is properly connected.
■ C heck the Anynet + device's Video/Audio/HDMI cable connections.
■ C heck whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
■ C heck whether the TV remote control is in TV mode.
■ Check whether it is Anynet+ exclusive remote control.
■
Anynet+ doesn't work in certain situations. (Searching channels, Plug & Play, etc.)
■
When connecting or removing the HDMI cable, please make sure to search devices
again or turn your TV off and on again.
■
Check if the Anynet+ Function of Anynet+ device is set on.
■ C heck if the Anynet + device is properly connected to the TV and check if the Anynet+
(HDMI-CEC) is set to On in the Anynet + Setup menu.
■ P ress the TV button on the TV remote control to switch to TV. Then press the TOOLS
button to show the Anynet + menu and select a menu you want.
■
Select View TV in the Anynet+ menu.
■
Press the SOURCE button on the TV remote control and select a device other than
Anynet+ devices.
■
Press CH, CH LIST and PRE-CH to change to the TV mode.
(Note that the channel button operates only when an Anynet+ device with a built-in tuner
is not connected.)
■ Y ou cannot use the remote control when you are configuring Anynet + or switching to a
view mode.
■ U se the remote control when the Anynet + setting or switching to view mode is complete.
You cannot use the play function when Plug & Play is in progress.
■ Check whether or not the device supports Anynet + functions.
■ C heck whether or not the HDMI cable is properly connected.
■ C heck whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
■ S earch Anynet+ devices again.
■ Y ou can connect an Anynet + device using the HDMI cable only. Some HDMI cables may
not support Anynet + functions.
Check whether the antenna jack on the recording device is properly connected.
English -
TV
P 1
View TV
Select Device
Record
Menu on Device
Device Operation
Receiver
:On
Setup
Move
Enter
Exit