Listening through a Receiver (Home theater)
You can listen to sound through a receiver instead of the TV speaker.
1. Press the TOOLS button. Press the ENTER E button to select Anynet+ (HDMI-CEC).
. Press the ▲ or ▼ button to select Receiver. Press the ◄ or ► button to select On or Off.
If your receiver supports audio only, it may not appear in the device list.
When listening through the receiver, there are restrictions for using the PIP and audio-related (MTS,
Preferred language) menus.
If there is a power interruption to the TV when the Receiver is set to On (by disconnecting the power
cord or a power failure), the Select Speaker may be set to External Speaker when you turn the TV on
Troubleshooting for Anynet +
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet + .
The message Connecting to
appears on the screen.
The Anynet + device does not
The connected device is not
The TV programme cannot be
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet + devices only.
Connect only one receiver (home theater).
Check if the Anynet + device power cord is properly connected.
Check the Anynet + device's Video/Audio/HDMI 1.3 cable connections.
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet+ setup menu.
Check whether the TV remote control is in TV mode.
Check whether it is Anynet + exclusive remote control.
Anynet+ doesn't work in certain situations. (Searching channels, Plug & Play, etc.)
When connecting or removing the HDMI 1.3 cable, please make sure to search devices again
or turn your TV off and on again.
Check if the Anynet + Function of Anynet + device is set on.
Check if the Anynet+ device is properly connected to the TV and check if the Anynet +
(HDMI-CEC) is set to On in the Anynet + Setup menu.
Press the TV button on the TV remote control to switch to TV. Then press the TOOLS button
to show the Anynet + menu and select a menu you want.
Select View TV in the Anynet + menu.
Press the SOURCE button on the TV remote control and select a device other than Anynet+
(Note that the channel button operates only when a tuner-embedded Anynet + device is not
You cannot use the remote control when you are configuring Anynet + or switching to a view
Use the remote control when the Anynet + setting or switching to view mode is complete.
You cannot use the play function when Plug & Play is in progress.
Check whether or not the device supports Anynet + functions.
Check whether or not the HDMI 1.3 cable is properly connected.
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
Search Anynet + devices again.
You can connect an Anynet + device using the HDMI 1.3 cable only. Some HDMI cables may
not support Anynet + functions.
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power
cord or a power failure, please repeat the device scan.
Check whether the antenna jack on the recording device is properly connected.
Menu on Device