Listening through a Receiver (Home theater)
You can listen to sound through a receiver instead of the TV speaker.
1. Press the TOOLS button. Press the ENTER E button to select Anynet+ (HDMI-CEC).
2. Press the ▲ or ▼ button to select Receiver. Press the ◄ or ► button to select On or Off.
If your receiver supports audio only, it may not appear in the device list.
The receiver will work when you have properly connected the Optical IN jack of the
receiver to the Optical Out jack of the TV.
When the receiver (home theater) is set to On, you can hear sound output from the
TV's Optical jack. When the TV is displaying a DTV(air) signal, the TV will send out 5.1
channel sound to the Home theater receiver. When the source is a digital component
such as a DVD and is connected to the TV via HDMI, only 2 channel sound will be heard from the Home Theater receiver.
When listening through the receiver, there are restrictions for using the audio-related menus.
If there is a power interruption to the TV when the
the Speaker Select may be set to External Speaker when you turn the TV on again. (see page 21)
Troubleshooting for Anynet +
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet + .
The message Connecting to
appears on the screen.
The Anynet + device does not
The connected device is not
The TV programme cannot be
The TV sound is not output
through the receiver.
Receiver is set to On (by disconnecting the power cord or a power failure),
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet
Connect only one receiver (home theater).
+ device power cord is properly connected.
Check if the Anynet
+ device's Video/Audio/HDMI 1.3 cable connections.
Check the Anynet
Anynet + (HDMI-CEC) is set to On in the Anynet+ setup menu.
Check whether the TV remote control is in TV mode.
Check whether it is Anynet
Anynet+ doesn't work in certain situations. (Searching channels, Operating WISELINK Pro,
Plug & Play, etc.)
When connecting or removing the HDMI 1.3 cable, please make sure to search devices again
or turn your TV off and on again.
+ Function of Anynet + device is set on.
Check if the Anynet
Check if the Anynet+ device is properly connected to the TV and check if the
(HDMI-CEC) is set to On in the Anynet + Setup menu.
TV button on the TV remote control to switch to TV. Then press the TOOLS button
to show the Anynet + menu and select a menu you want.
Select View TV in the Anynet
SOURCE button on the TV remote control and select a device other than Anynet+
(Note that the channel button operates only when a tuner-embedded Anynet
You cannot use the remote control when you are configuring Anynet
Use the remote control when the Anynet
You cannot use the play function when Plug & Play is in progress.
Check whether or not the device supports Anynet
Check whether or not the HDMI 1.3 cable is properly connected.
Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
+ devices again.
You can connect an Anynet
not support Anynet + functions.
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power
cord or a power failure, please repeat the device scan.
Check whether the antenna jack on the recording device is properly connected.
Connect the optical cable between TV and the receiver.
English - 37
+ exclusive remote control.
+ setting or switching to view mode is complete.
+ device using the HDMI 1.3 cable only. Some HDMI cables may
+ devices only.
+ device is not
+ or switching to a view