Operation
Turning the TV On and Off
Press the POWER button on the remote control.
You can also use the POWER button on the TV.
➢
It may take a while before you see a full picture.
Plug & Play Feature
When the TV is initially powered On, basic settings proceed automatically and subsequently:
The Screen Saver is activated if there is no operating signal for longer than 15 minutes.
1
Press the POWER button on the remote control.
The message Start Plug & Play. is displayed.
Press the ENTER button to enter the language.
Press the ▲ or ▼ button to select language, then press the ENTER button.
The message Select 'Home Use' when installing this TV in your home. is
automatically displayed.
Press the ◄ or ► button to select Store Demo or Home Use, then press the
ENTER button.
We recommend setting the TV to Home Use mode for the best picture in
➢
your home environment.
Store Demo mode is only intended for use in retail environments.
➢
If the unit is accidentally set to Store Demo mode and you want to return to
➢
Home Use (Standard) : Press the Volume button. While the volume OSD is
displayed, press and hold the MENU button for 5 seconds.
➢
The Screen Saver is activated if there is no remote control key input for
longer than 1 minute while "Plug & Play" is running.
4
Make sure that the antenna is connected to the TV.
Press the ENTER button.
The menu to select signal source is displayed.
Continued...
English - 15
Plug & Play
Start Plug & Play.
OK
Enter
Plug & Play
Language
:
English
Français
Español
Português
Move
Enter
Plug & Play
Select 'Home Use'
when installing this TV in your home.
Home Use
Store Demo
Move
Enter
Plug & Play
Check antenna input.
OK
Enter
Skip
Plug & Play
Air / Cable
:
Air
STD
HRC
IRC
Move
Enter
Skip