Table of Contents
Advertisement
Wired LAN Related
Q1 <Wake On LAN> Function.
A <Wake On LAN> is a function that activates the system in rest mode when a sig-
Q2 When I connected 100Mbps wired LAN and the computer exits
A When the computer exits standby/hibernate mode, restoring the network takes
7-16
Manual
nal (such as ping or magic packet commands) arrives from network(wired
LAN).
To use <Wake On LAN> function
1. Select My Network Environment > View Network Connections
from the Desktop.
2. Click the right button on the touchpad over Local Area Connection, and
select Properties.
3. Click Configure..., and select Power Management tab. Select 'Allow
this device to bring the computer out of standby', then click OK.
Restart the system.
If the system in rest mode is activated when there is no received signal, use the
system after disabling <Wake On LAN> function.
If you turn the power off when <Wake On LAN> is disabled, the LAN LED con-
tinues to be lit up.
Connecting wired LAN while using wireless LAN may not execute <Wake On
LAN> function. Configure wireless LAN to 'Disable' to use <Wake On LAN>
function.
1. Click on My Network Place> View network connections on the Desktop.
2. Right-click over Wireless Network Connection and select Disable.
standby/hibernate mode, a message informing 10Mbps wired
LAN connection appears.
about 3 seconds. When the network is restored, it operates in 100Mbps.
Advertisement
Table of Contents
