Get Started; Prepare The Remote Control; Turn On; Find The Correct Viewing Channel - Philips MCD120/93 User Manual

Philips component dvd micro system mcd120
Hide thumbs Also See for MCD120/93:
Table of Contents

Advertisement

4 Get started

Caution
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Caution
Risk of explosion! Keep batteries away from
heat, sunshine or fi re. Never discard batteries
in fi re.
1
Open the battery compartment.
2
Insert 2 x 1.5V AAA batteries with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Note
Before you press any function button on the
remote control, fi rst select the correct source
with the remote control.
If you are not going to use the remote control
for a long time, remove the batteries.
12
EN

Turn on

1
Press
.
»
The display panel displays
To switch to standby mode, press
again.
»
The standby indicator on left side
of display panel switches to red.
Find the correct viewing
channel
1
Press
to turn on the unit.
2
Press DISC / USB to switch to disc mode.
3
Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
Go to the lowest channel on your
TV, then press the Channel Down
button until you see the blue screen.
Press the source button repeatedly
on the remote control of your TV.
Tip
The video-in channel is between the lowest
and highest channels and may be called
FRONT, A/V IN, VIDEO etc. See the TV user
manual on how to select the correct input on
the TV.
Select TV system that match
the connected TV
This DVD player is compatible with both NTSC
and PAL. For the playback of a DVD disc on this
DVD player, the color systems of the TV set and
DVD player should match.
1
Press SETUP .
2
Select [SYSTEM SETUP] > [TV SYSTEM] ,
and then press .
LOAD .

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mcd120

Table of Contents