Download  Print this page

Features; Commom Drying Problems - Frigidaire 137232600A Use And Care Manual

27” (69 cm) wide laundry center
Hide thumbs



Use the drying rack to dry items which
should not be tumbled.
Common Drying
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage. For
satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association.
•Fabric softener sheet.
Greasy, oily
• Overloading.
• Overdrying causes static
•Lint screen not clean when
cycle began.
•Lint is attached to "pills."
•Pilling is normal with
synthetic and permanent
(Fibers break off,
press fabrics. This is due to
ball up and cling
abrasion from normal
to fabric.)
•Leaving items in dryer after
cycle ends.
Cycle Signal Control (some models)
When the Cycle Signal Control is ON, a signal will sound at the end of each
cycle and during the Press Saver setting (some models). The volume is
adjustable on some models.
Drum Light (some models)
A drum light will come on whenever the door is opened to illuminate the dryer
drum during loading and unloading. Closing the door turns off the light.
Drying Rack (some models)
Use the drying rack to dry items which should not be tumble dried.
1. Open the dryer door and remove the lint screen.
2. Insert drying rack into the dryer drum. Place the front bar under the lip
of the lint screen opening.
3. Place items to be dried on top of rack. Weight should not exceed 10 lbs.
Leave space between items, but do not let items hang over the sides or
through the grids. Do not tumble other items when using the drying rack.
4. Select a timed dry setting best suited for items being dried. Use only the
Air Fluff (no heat) temperature setting for items containing plastic, foam
rubber, rubber-like materials, feathers or down.
5. When items are dry, remove the rack and replace the lint screen. If lint
screen is not in place, tumbling items could enter the exhaust system and
cause damage to the dryer.
•Rub fabric softener stains with bar
Rinse and rewash.
•Reduce load size and rewash using
liquid fabric softener in the final rinse.
•Or, add a fabric softener sheet and
tumble without heat.
•Use lint brush or roller to remove lint.
•Use a lint brush or shaver to remove
•Irreversible condition.
•Reduce load size and tumble at
medium or low heat for 5-10 minutes.
•Remove items immediately. Hang or
•Add a few bath towels to small loads for proper
•Some "silk-like" fabrics should be air dried.
•Use proper drying temperature.
•Place fabric softener sheet on top of load before
starting the dryer.
•Do not overload dryer.
•Use fabric softener in washer or dryer to reduce
static electricity.
•Remove items when they are slightly damp to
avoid overdrying.
•Check that lint screen is clean and in place.
•Use fabric softener to lubricate fibers.
•When ironing, use spray starch or fabric finish on
collars and cuffs.
•Turn items inside out to reduce abrasion.
•Follow fabric care label directions.
•If shrinking is a concern, check load often.
•Remove items while slightly damp.
•Block knits into shape.
•Lay flat to complete drying.
•Do not overload dryer.
•Remove items as soon as cycle ends.

Hide quick links:



  Related Manuals for Frigidaire 137232600A