Drying Rack (some models)
Use the drying rack to dry items which should not be
tumble dried. If your model did not come with a drying
rack, you may order one.
Place the front bar
under the lip of the lint
1. Open the dryer door and remove the lint screen.
2. Insert drying rack into the dryer drum. Place the front
bar under the lip of the lint screen opening.
3. Place items to be dried on top of the rack. Weight
should not exceed 10 Ibs. Leave space between items,
but do not let items hang over the sides or through
the grids. Do not tumble other items when using the
4. Select a timed cycle. If items to be dried contain
plastic, foam rubber, rubber-like materials, feathers or
down, then only use the air dry temperature
5. When items are dry, remove the rack and replace
the lint screen. If lint screen is not in place, tumbling
items could enter the exhaust system and cause
damage to the dryer.
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric
by The Soap and Detergent
off, ball up and
cling to fabric.)
Wri nkli ng
• Fabric softener sheet,
• Overdrying causes static
• Lint screen not clean when
Lint is attached to "pills."
• Temperature too high.
• Rub fabric softener stains with
bar soap, Rinse and rewash.
Leaving items in dryer after
Reduce load size and rewash
using liquid fabric softener in the
• Or, add a fabric softener sheet
and tumble without heat.
Use lint brush or roller to remove
• Use a lint brush or shaver to
• Reduce load size and tumble at
medium or low heat for 5-10
• Remove items immediately. Hang
Add a few bath towels to small loads
for proper tumbling.
Some "silk-like" fabrics should be air
Use proper drying temperature.
Place fabric softener sheet on top of
load before starting the dryer.
Do not overload dryer.
Use fabric softener in washer or dryer
to reduce static electricity.
Remove items when they are slightly
damp to avoid overdrying.
Check that lint filter is clean and in
Use fabric softener to lubricate fibers.
When ironing, use spray starch or
fabric finish on collars and cuffs.
Turn items inside out to reduce abra-
Follow fabric care label directions.
If shrinking is a concern, check load
Remove items while slightly damp and
hang or lay fiat to complete drying.
Block knits into shape.
Do not overload dryer.
Remove items as soon as cycle ends.