Safety - Xerox Phaser 3160B User Manual

safety

SAFETY INTRODUCTION
Notices and Safety
Please read the following instructions carefully before operating the machine and refer to them as needed to ensure the continued safe
operation of your machine.
Your Xerox product and supplies have been designed and tested to meet strict safety requirements. These include safety agency evaluation
and certification, and compliance with electromagnetic regulations and established environmental standards.
The safety and environment testing and performance of this product have been verified using Xerox materials only.
WARNING: Unauthorized alterations, which may include the addition of new functions or connection of external devices, may impact the
product certification. Please contact your Xerox representative for more information.
MARKS AND LABELS
Symbols
RADIO FREQUENCY EMISSIONS
FCC Notices For The USA
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not specifically approved by the Xerox Corporation may void the user's authority to operate this
equipment.
EME Compliance for Canada
This Class "B" digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe « B » est conforme à la norme NMB-003 du Canada.
WARNING This symbol alerts users to areas of the equipment where there is the possibility of personal injury.
This symbol alerts users to areas of the equipment where there are heated or hot surfaces, which should
WARNING
not be touched.
This symbol alerts users to areas of the equipment which require special attention to avoid the possibility of
CAUTION
personal injury or damage to the equipment.
This symbol indicates a Laser is being used in the equipment and alerts the user to refer to the appropriate
WARNING
safety information.
This symbol identifies information that is being emphasized and is important for you to remember.
NOTE
Safety_ 7