System Setup; Setup Mode; Setup Screen (Main Setup); Brightness - Acura 2010 RL Navigation System Owner's Manual

System Setup

SETUP Mode

The SETUP function consists of two
main screens that allow you to change
and update information in the system.
To display the SETUP screen (Main
Setup), use the voice control system
and say "Setup" or press the SET UP
button. To change it to the SETUP
screen (Other), select the "Other" tab.
You can switch screens by selecting the
tab.
You can use the voice control system to
select any item on the SETUP screen.
92
Navigation System
NOTE:
• If some items appear to be grayed out
and cannot be selected, it is because
you did not select OK on the initial
Disclaimer screen. See System Start-
up on page 17.
• Setup items in this manual with the
symbol indicate that the display
settings depend on what "Driver #"
was displayed on the MID when the
vehicle was started. See Remote
Keyless Entry Setting on page 18.
• If only "Welcome" is displayed, then
all Setup settings revert to factory
defaults, and all personal data (such
as Address Book or Calendar) are not
available.
• For information on the available
voice commands, see Voice
Command Index on page 166.
2010 RL

SETUP Screen (Main Setup)

From any screen, say "Setup screen" or
press the SET UP button, and the
following screen appears:

Brightness

The screen brightness has 11 settings.
To change the brightness, use the voice
control system and say "Brightness up"
or "Brightness down." You can also
select Brightness and change the
setting by rotating the Interface Dial
knob.
Tip:
If you are having trouble viewing the
screen in bright lighting conditions, try
increasing the brightness.