Advertisement
3.
NAVIGATION SYSTEM SETUP AT THE TQI
The navigation system is basically ready to use when the vehicle is delivered to the dealership. The system has features
to reduce the potential for driver distraction. Some touch screen menus are limited or unavailable (grayed out) while
driving to encourage the use of voice commands for the navigation and audio systems.
Since the navigation system interfaces with other vehicle systems, it is important that all of the systems are initialized. To
initialize the navigation system, follow these steps:
3.1. Do the regular TQI of the vehicle.
3.2. Turn the ignition to ON.
•
If you see this screen, select OK, then go to step 3.4
NOTE
Selecting OK is optional; the screen will change on its own.
•
You may see the factory InLine Diag screen below, which means the audio-navigation unit is in the factory
diagnostic mode. If you do, follow these steps to exit the mode; otherwise, skip them, and go to step 3.3.
–
Select Start Diag.
–
Press all of the buttons on the steering wheel that are shown in the InLine Diag screen. The icons should
turn green. If any of them are red, troubleshoot the applicable system. See the service information for
more information.
–
Press and release the Talk button and, in a normal voice, say "Testing." The mic level indicator must reach
at least six bars.
–
When you have completed all of the tests, the icons will be green. Select Exit Diag to exit the mode.
–
Turn the ignition to OFF, then to ON, to make sure the InLine Diag screen does not reappear.
Page 3 of 7
Advertisement
