Advertisement
3.
NAVIGATION SYSTEM SETUP AT THE TQI
The navigation system is basically ready to use when the vehicle is delivered to the dealership. The system has
features to reduce the chance of driver distraction. Some touch screen menus are limited or unavailable (grayed out)
while driving to encourage using voice commands for the navigation and audio systems.
Since the navigation system interfaces with other vehicle systems, it is important that all of the systems are initialized.
To initialize the navigation system, follow these steps:
1. Do the regular TQI of the vehicle.
2. You may see the factory In Line Diag screen below. If so, do the following or the screen will come back every
time the engine is started. If not, go to step 3.
•
Select Start Diag.
•
Press and hold the DEST/ROUTE, MAP/GUIDE, and CANCEL buttons at the same time until the Select
Diagnosis Items screen appears. Then release the buttons.
•
Make a loud sound (like snapping your fingers or clapping your hands) by the microphone to complete the
mic test.
•
When you have completed all of the tests, the icons will be green. Select Exit Diag to exit the screen.
•
Set the power mode to OFF, then to ON to make sure the In Line Diag screen does not reappear.
3. Start the engine, and park the vehicle in an open area away from trees, power lines, and tall buildings. Remove
loose articles, cell phones, and electrical accessories near the GPS antenna. If needed, press the audio-
navigation power button to turn on the audio-navigation unit. When the Enter code screen appears, press and
hold the power button for about 2 seconds. This lets the PCM check that the vehicle's VIN matches the one
saved in the unit. You will hear a long beep when the unit exits the anti-theft mode. Release the button.
Page 3 of 7
Advertisement
