Table of Contents
Advertisement
Ant/Cable/Satellite (if available)
From this menu, you can set the RF input configuration.
a
Press MENU, and select SETUP menu.
b
b
Use
to highlight Ant/Cable/Satellite and use
c
to select Antenna, Cable or Satellite.
NOTE: When you attempt to change the Ant/Cable/
Satellite setting, a warning message will appear
followed by PIN entry (if PIN has been set) and a
prompt for Auto Tuning.
c
When Ant/Cable/Satellite is set to Cable, the
following setting options will be provided in the Auto
Tuning screen.
B
b
Press
or
to select an item, and then press
to select your desired option.
Auto Tuning
Tuning Mode
Start Scan
DTV
Scan Type
Start Frequency
End Frequency
Modulation
Symbol Rate
Network ID
With the exception of DTV Scan Type and DTV Modulation
items, all of the following items will have 2 operating modes.
The first is Auto where the values for each item are preset by
the system. The second is an Input mode where you will be
able to enter a single value in place of the pre-set value. If no
channel is currently tuned and the Input state is chosen, a
system default value will be shown. However, if a channel is
currently tuned when the item is accessed, the value of the
current channel will be displayed.
DTV Scan Type:
This item determines whether a Quick Scan or a Full Scan will
be executed.
The Quick Scan is a simplified version of the Full Scan that is
designed to complete in less time.
DTV Start Frequency:
This sets the frequency from which the scan will begin.
C
or
C
c
or
DTV and ATV
Quick Scan
Auto
Auto
Auto
Auto
Auto
17
DTV End Frequency:
This sets the frequency at which the scan will end.
DTV Modulation:
You can choose from five QAM modulation settings.
DTV Symbol Rate:
This is the baud rate (KS/s) of the scan.
DTV Network ID:
This is the Network ID to be utilized for the scan. This item is
greyed out when DTV Scan Type is set to "Full Scan".
Satellite Settings
From the SETUP menu, you can add the satellites that you wish
to tune and configure detailed settings for each one
individually.
To add a satellite:
a
Press MENU and use
b
b
Use
to highlight Satellite Settings. Press OK.
Satellite Settings
Switch Type
LNB Power
No.
Satellite
ASTRA 19.2˚E
1
2
3
4
Transponder : 1/83 (10743 MHz)
Dish Type : Fixed
Lower LOF (MHz) : 9600
Upper LOF (MHz) : 10600
c
b
Press
to highlight a new line to add an another
satellite, and press OK.
d
b
Press
until the required satellite is displayed and press
OK.
SETTING UP YOUR TV
C
c
or
to select SETUP menu.
None
On
Dish
LNB
1
1
Done
Advertisement
Table of Contents
