Adjustment Setup - Haier HLH32BB Owner's Manual

Adjustment Setup

Adjustment Setup
Adjusting setup
In VGA and DVI input mode , H Position and V Position can be used to
adjust the picture position.
When VGA DVI input mode is set
1. Press MENU button on the remote control and
option of picture position adjust(ADJ).
Press to enter the menu of picture position setup
2.
/
3. Press / button for desired adjust parameter option.
4. Press / for desired adjust parameter option until
satisfactory value is achieved. When VGA signals are
received , the automatic mode (Auto Sync) is used for
parameter adjustment
Note:
Adjust, RGB and Reset are functional only under VGA and DVI mode, and Auto Sync is functional only in VGA mode.
1)Adjust is opted for adjusting H Position and V Position as well as relative
parameters in VGA and DVI modes.(Phase Adjust is not
available in DVI)
2)RGB is opted for adjustment of the numerical value of red,
green and blue in VGA/DVI mode.
3)Reset is opted for adjustment of parameters (After the
operation, Complete will be on the right of the option)
4)Auto Sync is opted for adjustment of picture location freque-
ncy and phase parameters in VGA mode.(Not available in
DVI) (After the operation, Complete will be on the right of
the option)
5) Under the VGA signal, there are Full Screen , One to One and
4:3 Mode for Display mode to select.
Under the AV1/ S-Video/AV2 signal, there are Full Screen,
Vertical Zoom, Half Zoom, Panorama and 4:3 Mode for
Display Mode to select.
Under the DVI signal, there are Full Screen and 4:3 Mode for
Display Mode to select.
6) Color Temperature is opted for color parameters of Cold,
Normal and Warm.
20 LCD TV Monitor
for
/
A
B
C
0
0
0
0
0
A
B
C
0
0
0
A
B
C
Not
available