Gigabyte GA-D425TUD User Manual page 18

6) SATA2_0/1 (SATA 3Gb/s Connectors, Controlled by NM10 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
7) GSATA2_0/1 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2/JMicron
JMB363)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device. The GIGABYTE SATA2/JMicron JMB363 con-
troller supports RAID 0, RAID 1, and JBOD. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for
instructions on configuring a RAID array.
A RAID 0 or RAID 1 configuration requires at least two hard drives.
Hardware Installation
DEBUG
PORT
1
SATA2_1
DEBUG
SATA2_0
PORT
7
DEBUG
PORT
1
GSATA2_0
GSATA2_1
7
Please connect the L-shaped end of
the SATA cable to your SATA hard
drive.
- 18 -
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND