Gigabyte GA-945P-S3 User Manual page 44

Turbo
Full Thrust
Warning: Stability is highly dependent on system components.
CPU Host Clock Control
Please note that if your system is overclocked and cannot restart, please wait 20secs.
for automatic system restart or clear the CMOS setup data and perform a safe restart.
Disabled
Enabled
CPU Host Frequency (Mhz)
100MHz ~ 600MHz
If you use a 533 MHz FSB processor, set "CPU Host Frequency" to 133 MHz.
If you use an 800 MHz FSB processor, set "CPU Host Frequency" to 200 MHz.
If you use a 1066 MHz FSB processor, set "CPU Host Frequency" to 266 MHz.
Incorrect using it may cause your system broken. For power End-User use only!
PCI Express Frequency (Mhz)
Auto
90~150
System Memory Multiplier
The adjustable range will vary based on the CPU FSB. Default value: Auto (set memory
frequency by DRAM SPD data). Wrong frequency settings may cause system unable to boot.
Clear CMOS to overcome wrong frequency issue.
Memory Frequency (Mhz)
The values depend on CPU Host Frequency (Mhz) and System Memory Multiplier setting.
DIMM OverVoltage Control
Please note that by overclocking your system through the increase of the DIMM voltage, damage
to the memory may occur.
Normal
+0.1V ~ +0.6V
PCI-E OverVoltage Control
Normal
+0.1V ~ +0.3V
FSB OverVoltage Control
Normal
+0.1V ~ +0.3V
CPU Voltage Control
Supports adjustable CPU vcore. The adjustable range is dependent on CPUs.
(Default value: Normal)
Please note that by overclocking your system through the increase of the CPU voltage, damage
to the CPU or decrease in the CPU life expectancy may occur.
Normal CPU Vcore
Display your CPU's normal voltage.
GA-945P-S3 Motherboard
Set C.I.A.2 to Turbo. (Automatically increase CPU frequency(15%,17%) by
CPU loading.
Set C.I.A.2 to Full Thrust. (Automatically increase CPU frequency(17%,
19%) by CPU loading.
Disable CPU Host Clock Control. (Default value)
Enable CPU Host Clock Control.
Set CPU Host Frequency from 100MHz to 600MHz.
Set PCI Express frequency automatically. (Default value)
Set PCI Express frequency from 90MHz to 150MHz.
Supply DIMM voltage as DIMM required. (Default value)
Increase DIMM voltage by +0.1V to +0.6V.
Supply PCI-E voltage as PCI-E required. (Default value)
Increase PCI-E voltage by +0.1V to +0.3V.
Supply FSB voltage as FSB required. (Default value)
Increase FSB voltage by +0.1V to +0.3V.
- 44 -