Gigabyte GA-945P-S3 User Manual page 37

USB 2.0 Controller
Disable this function if you are not using onboard USB 2.0 feature.
Enabled
Disabled
USB Keyboard Support
Enabled
Disabled
USB Mouse Support
Enabled
Disabled
Legacy USB storage detect
This option allows users to decide whether to detect USB storage devices, including USB flash
drives and USB hard drives during POST.
Enabled
Disabled
Azalia Codec
Auto
Disabled
Onboard H/W LAN
Enabled
Disabled
OnBoard LAN Boot ROM
This function decide whether to invoke the boot ROM of the onboard LAN chip.
Enabled
Disabled
Onboard Serial Port 1
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Onboard Parallel port
Disabled
378/IRQ7
278/IRQ5
3BC/IRQ7
Parallel Port Mode
SPP
EPP
ECP
ECP+EPP
ECP Mode Use DMA
This option is available only when Parallel Port Mode is set to ECP or ECP+EPP.
3
1
Enable USB 2.0 Controller. (Default value)
Disable USB 2.0 Controller.
Enable USB Keyboard Support.
Disable USB Keyboard Support. (Default value)
Enable USB Mouse Support.
Disable USB Mouse Support. (Default value)
BIOS will scan all USB storage devices. (Default value)
Disable this function.
Auto detect Azalia audio function. (Default value)
Disable Azalia audio function.
Enable Onboard H/W LAN function. (Default value)
Disable this function.
Enable this function.
Disable this function. (Default value)
BIOS will automatically setup the port 1 address.
Enable onboard Serial port 1 and address is 3F8/IRQ4. (Default value)
Enable onboard Serial port 1 and address is 2F8/IRQ3.
Enable onboard Serial port 1 and address is 3E8/IRQ4.
Enable onboard Serial port 1 and address is 2E8/IRQ3.
Disable onboard Serial port 1.
Disable onboard LPT port.
Enable onboard LPT port and address is 378/IRQ7. (Default value)
Enable onboard LPT port and address is 278/IRQ5.
Enable onboard LPT port and address is 3BC/IRQ7.
Using Parallel port as Standard Parallel Port. (Default value)
Using Parallel port as Enhanced Parallel Port.
Using Parallel port as Extended Capabilities Port.
Using Parallel port as ECP & EPP mode.
Set ECP Mode Use DMA to 3. (Default value)
Set ECP Mode Use DMA to 1.
- 37 - BIOS Setup