Gigabyte nForce series Configuration page 7

After that, the Array List screen displaying the RAID array you created will appear (Figure 9).
If you want to set the disk array as boot device, use the UP or DOWN ARROW key to select the array
and press B.
[ C t r l- X ] E x it
If you want to read more information about the RAID array, press ENTER to enter the Array Detail screen
(Figure 10), where you can see detailed information about RAID mode, disk block size, disk model name,
and disk capacity, etc.
R A I D M o d e : M i r r o r i n g
S t r ip in g W id t h : 1
A d a p t
1
1
[ R ] R e b u ild
If you need to clear the data in the hard disk, press C in this screen. When the Clear disk data screen
appears, press Y to confirm or N to cancel. Press ENTER to return to the Array List screen.
To exit the Nvidia RAID utility, press CTRL+X.
Now, you can proceed to install the SATA controller driver and operating system.
NV I D I A R A I D Ut il it y
Bo o t I d S t a t u s
BBS 2 H e a l t h y
[ h i ] S e le c t
[ B] S e t Bo o t
A r r a y 2 : NV I D I A M I R R O R 1 11 . 7 9 G
- A r r a y D e t a il -
C h an n e l M / S
0 M a s t e r
1 M a s t e r
[ D ] D e le t e
Ma y 10 2 00 4
- A r r a y L i s t -
Ve n d o r A r r a y M o d e l N a m e
NV I D I A M I R R O R
[ N ] N e w A r r a y
Figure 9
S t r ip i n g Blo c k :
I n d e x D i s k M o d e l N a m eC a p a c i t y
0 S T 3 1 20 0 2 6 A S
1 S T 3 1 2 0 0 2 6 A S
[ C ] C le a r D is k
Figure 10
- 7 - SATA Hard Drive Configurations (nForce series)
1 1 1 . 7 9 G
[ E N TE R ] D e t a il
1 1 1 . 7 9 G B
1 1 1 . 7 9 G B
[ E N TE R ] R e t u r n