Gigabyte nForce series Configuration page 12

Step 4:
When the next screen (Figure 19) appears, press ENTER to continue the SATA driver installation from
the floppy disk. The driver installation will be finished in about one minute.
Windows Setup
S=Specify Additional Device Enter=Continue F3=Exit
After the SATA controller driver installation is completed, you should see a screen as below. It indicates
that you have installed the SATA controller driver successfully. You can proceed with the Windows
2000/XP installation.
WindowsXP Professional Setup
Welcome to Setup.
This port of the Setup program prepares Microsoft(R)
Windows (R) XP to run on your computer.
Enter= Continue
SATA Hard Drive Configurations (nForce series) - 12 -
Setup will load support for the following mass storage device(s):
NVIDIA RAID CLASS DRIVER
NVIDIA NForce Storage Controller
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
To set up Windows XP now, press ENTER.
To repair a Windows XP installation using
Recovery Console, press R.
To quit Setup without installing Windows XP, press F3.
R=Repair
Figure 19
F3=Exit
Figure 20