Gigabyte nForce series Configuration page 11

Step 3:
If Setup correctly recognizes the driver in the floppy disk, a controller menu similar to Figure 17 below
will appear. Use the ARROW keys to select NVIDIA RAID CLASS DRIVER* (Figure 17) and press
ENTER. Later, when a screen similar to Figure 18 appears, you must press S to select additional driver.
The screen will return to previous screen as shown in Figure 17. Select NVIDIA NForce Storage
Controller and press ENTER, and then it will begin to load the SATA driver from the floppy disk.
Windows Setup
You have chosen to configure a SCSI Adapter for use with Windows,
Windows Setup
S=Specify Additional Device Enter=Continue F3=Exit
If a message appears saying one or some file(s) cannot be found, please check the floppy disk
or copy the correct SATA driver again from the motherboard driver CD.
"*" If you want to create RAID, select both NVIDIA RAID CLASS DRIVER and then NVIDIA
NFo rce Storage Controller.
If you do not create RAID, select NVIDIA NForce Storage Controller only.
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
NVIDIA RAID CLASS DRIVER
NVIDIA NForce Storage Controller
ENTER=Select F3=Exit
Setup will load support for the following mass storage device(s):
NVIDIA RAID CLASS DRIVER
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Figure 17
Figure 18
- 11 - SATA Hard Drive Configurations (nForce series)