For The Installer; Electrical Connections - Electrolux EMS 2185 Instruction Booklet

EMS 2185
1. Remove any promotion label from the door.
2. This oven can be used as a free standing oven or
built-in, into a kitchen cabinet using kit number
JMR260, which is supplied with the oven. To
install the oven in a kitchen cabinet follow the
instructions supplied with the building-in kit.
The oven should be installed on a flat, level surface.
The surface must be strong enough to safely bear
the weight (18 kg) of the oven, and the contents.
To avoid the possibility of causing vibration or
noise the oven must be in a stable position.
3. Keep the oven away from heat and water. Exposure
to heat and water can lower oven efficiency and
lead to malfunctioning, so be sure to install the
oven away from heat and water sources.
Do not block air vents on the top and the sides of
4.
the cabinet and also do not place any articles on
the top of the oven. A gap all around the oven is
necessary : 100 mm above the oven and any
objects, 50 mm on the sides and behind the oven.
If air vents are blocked during operation, the oven
may overheat, and this may lead to malfunctio-
ning. Hot air escapes from the vents, so be sure not
to obstruct it or let curtains come between the
oven and the rear wall.
5. Place the oven as far away from radios and TV's as
possible. This oven does conform to EEC require-
ments* of radio interference suppression, but
some interference may occur if it is placed too
close to a radio or TV, so keep them as far apart as
possible.
6. If positioned in a corner, leave a gap of at least
5 cm from the right side wall.
IMPORTANT! The oven can be placed almost
anywhere in the kitchen. Make sure the oven is
placed on a flat, level surface and that vents as
well as the surface underneath the oven are not
blocked (for sufficient ventilation).

Electrical connections

THIS APPLIANCE MUST BE EARTHED.
!
The manufacturer declines any liability
should this safety measure not be observed.

For the installer

If the plug that is fitted to your appliance is not suit-
able for your socket outlet, it must be cut off and the
appropriate plug fitted.
Remove the fuse from the cut off plug. The cut off
plug should then be disposed of to prevent the hazard
of shocks in case it should be plugged into a 13 Amp
socket in another part of your home.
IMPORTANT
The wires in the mains lead are coloured in accor-
dance with the following code:
GREEN AND YELLOW
BLUE
BROWN
If you fit your own plug, the colours of the wires in
the mains lead of your appliance may not correspond
with the markings identifying the terminals in your
plug, proceed as follows:
Connect the green and yellow (earth) wire to the ter-
minal in the plug which is marked with the letter 'E'
or the earth symbol (
low.
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter 'N' or coloured
black.
Connect the brown (live) wire to the terminal in
the plug which is marked with the letter 'L' or coloured
red.
31
EARTH
NEUTRAL
LIVE
) or coloured green and yel-
UK