Advertisement
HOW TO OPERATE
TEMPERATURE CONTROL
Temperature is controlled automatically. The TEMPERATURE CONTROL at
the inside of the refrigerator and freezer section control the degree of cooling
of each compartment.
Freezer Temperature Control
The control has four settings form
to WINTER. The WINTER mode
is available only if atmosphere
temperature is below 10°C.
Starting your new refrigerator
1. Clean the refrigerator thoroughly. Wipe the outside with a dry cloth, and the
inside with a damp cloth.
2. Set the temperature control knob at normal position.
3. Connect the power supply cord.
To control temperature
Many factors may influence the internal temperature of the
refrigerator and freezer compartments.
ßö
The temperature and humidity of the surrounding environment.
ßö
The opening frequency of the doors and the amount of warm food placed
in the refrigerator.
ßö
The combination of food and containers stored in the refrigerator.
For these reasons, you may want to adjust the control to suit the season
and your needs.
Refrigerator Temperature Control
The control has the four settings from
to WINTER. The WINTER mode is
available only if atmosphere
temperature is below 10°C.
9
ßö
Turn the temperature control in the refrigerator and freezer compartments
toward WINTER for colder temperature and toward
for warmer temperature.
ßö
Allow approximately 12 hours or overnight for the temperature to stabilize.
Then check to see if further adjustments are necessary.
To turn off the refrigerator
Disconnect the power supply cord. Remove icing case and food. Leave doors
ajar for ventilation and dehumidification of both compartments.
2. DEFROSTING THE REFRIGERATOR
You will never have to defrost your refrigerator as it is designed to defrost itself
completely and automatically.
C A U T I O N
To avoid the risk of electric shock or death, unplug the power
cord before replacing a burned out light bulb or cleaning the inner
parts.
3. RADIANT HEAT
With the Refrigerating System in operation, it is likely that the cabinet will feel
warm at the front edges and sides. This does not indicate trouble.
It is due to the hot-line used in this type of Refrigerating System which
consists of piping hot gas from the (motor-driven) compressor along the front
edges, the sides of the cabinet and the center partition to prevent dewing.
This has nothing to do with the storage temperature inside.
(The thick line indicates the hot-line)
N O T E : During spells of hot, humid weather and in rainy
season, moisture may develop on the cabinet,
just as water condenses around a cold glass of
water. It is not an abnormal condition; wipe off
the moisture with a dry cloth. This can also
happen when the refrigerator is not installed in
an appropriate place.
10
Advertisement
