Table of Contents
Advertisement
Replacing Freezer Door
Insert the bottom hole of freezer
1
Insert the water tube into the hole of
2
the bottom hinge pin first, then
door straight to the bottom hinge pin.
Insert the bottom of freezer door into
the bottom hinge pin.
4
Turn the hinge fastener tightly to the
5
Insert the water tube far into the
end.
coupling.
Connect harness wirings and screw
ground wire.
Replacing Refrigerator Door
Insert the bottom hole of refrigerator
Let the top of door close to the
1
2
door straight to the bottom hinge pin
cabinet and insert the top hinge pin
to the top hole of freezer door.
( Insert the back of hinge to the
groove of protrusion first, then front
to the top hole of door.)
!
!
@
@
3
Let the top of door close to the
cabinet and insert the top hinge
pin to the top hole of freezer door.
( Insert the back of hinge to the
groove of protrusion first, then
front to the top hole of door.)
@
!
!
3
Turn the hinge fastener tightly to the
end.
Connect harness wirings and screw
ground wire.
Click and screw the top hinge
cover.
!
@
!
18
Refrigerator Leveling &
Door Adjustment ( If needed. )
Refrigerator must be level in order to maintain optimal performance and desirable front appearance.
(If the floor beneath the refrigerator is uneven, freezer and refrigerator doors look unbalanced.)
In case freezer door is lower than refrigerator door...
1
Insert a screw driver (flat tip) into a
2
Open the doors, unscrew the front
groove of the left wheel (bottom of
cover and remove, if it is attached.
freezer) and turn it clockwise until the
door is balanced. (clockwise to raise
freezer door ; counterclockwise to lower)
Unless the freezer door is balanced
by step 1, then follow the next steps.
The front of refrigerator needs to be higher just a little than the back for easy
Caution
door closing, but if the wheel is raised too much for door balance, i.e. front of
refrigerator is too higher than the back, it can be difficult to open the door.
In case refrigerator door is lower than freezer door...
1
Insert a screw driver (flat tip) into a
2
Loosen 3 hinge bolts(2 on the left + 1
groove of the right wheel (bottom of
on the right) a little. (Do not unfasten
refrigerator) and turn it clockwise until
them completely.)
the door is balanced. (clockwise to
Insert a hexagonal wrench into the
raise refrigerator door ;
groove of adjusting nut and turn
counterclockwise to lower)
clockwise until the door is level.
Unless the refrigerator door is
balanced by step 1, then follow the
next steps.
Front Cover
After installation and/or door leveling, fasten front cover
with screws.(Remove the screws on the front bottom
panel first. Click and screw the cover)
3
Loosen 3 hinge bolts(1 on the left + 2
on the right) a little. (Do not unfasten
them completely.) Insert a hexagonal
wrench into the groove of adjusting
nut and turn clockwise until the door
is level.
4
Once the door is balanced, fasten the
hinge bolts tightly and screw the front
cover.
#
$
Hinge Bolt
3
Once the door is balanced, fasten
the hinge bolts tightly.
Attaching of Water Filter Holder
Remove the back paper of the tape on the filter
holder and attach the filter holder on a suitable
place.
19
Hide quick links:
Advertisement
Table of Contents
