Initial Installation; Setting Time And Date / Auto Clock - Daewoo DX-9810 Instruction Manual

Initial Installation

Switch the TV on.
You can also start "AUTO SEARCH" in the SETUP "PR PRESET"
To tune in new stations (manual tuning) and to enter station names see page 25-26.
Setting up the player
1
You should see this picture the first time you switch on the TV
and player.
Choose your language.
2 Then choose your country.
For selecting the country, refer to the followings.
B: Belgium I: Italy
D: Germany LUX: Luxembourg
DK: Denmark N: Norway
E: Spain NL: Netherlands
GR: Greece S: Sweden
OK for "AUTO SEARCH!".
3
"AUTO SEARCH" tunes in all the stations you can receive in your
country.
If other stations are positioned on near the current RF OUTPUT
4
CH, the guide message appears automatically.
The player recommends the optimal RF OUTPUT CH number
automatically.
Press the [OK] button to confirm the recommended PR.
5
Should you wish the stations to have the same numbers as those
used on the TV, follow the instructions in "Sorting programme
locations" on page 26.
Else ...
exit the basic installation function and enjoy your player.
• If you don´t see this picture, because you don´t use a SCART cable,
search this picture now (CH 52) with the station tuning functions of
your TV set (see its user manual).
• In case of interference problems on CH 52, type in an
other transmission channel between 21 and 69 using
the number buttons.
18
"AUTO SEARCH".
LANGUAGE SET
ENGLISH
DEUTSCH
ITALIANO
ESPAÑOL
FRANÇAIS
NEDERLANDS
PR+/-:SELECT
OK:CONFIRM SETUP:END
COUNTRY SET
B N
SF: Finland D NL
DK S
E SF
CH: Switzerland
GR CH
I TR
TR: Turkey
LUX OTHERS
PR+/-:SELECT
OK:CONFIRM SETUP:END
CH 25
PLEASE WAIT...
SETUP:END
RF OUTPUT SET
CURRENT CH 52
RECOMMENDED CH 54
0-9:SELECT(21-69)
OK:CONFIRM SETUP:END
IMPORTANT!
PLEASE CHANGE THE TV
CH TO 54.
MANUAL SET
PR01 ARD PR08 P-08
PR02 ZDF PR09 P-09
PR03 P-03 PR10 P-10
PR04 P-04 PR11 P-11
PR05 MTV PR12 ----
PR06 P-06 PR13 ----
PR07 P-07 PR14 ----
PR+/-:SELECT
OK:CONFIRM SETUP:END
Setting time and date
Setting time and date
Press [VCR] button on the remote control to change into VCR Mode and follow the procedure
below.
1 Call the player's "SETUP",
choose "VCR SETUP", then "CLOCK SET".
Move to the position you want to change and type in the
2
new values.
Wait a few seconds after typing a one-digit number.
Store with [OK] button and exit with [SETUP] button.
CLOCK SET
TIME - - : - -
DATE - - / - - /- - - -
0-9:SETUP (HOUR)
/ :CORRECT SETUP:END
CLOCK SET
TIME 06:05
DATE 08/08/2004(SUN)
0-9:SETUP (HOUR)
/ :CORRECT
OK:CONFIRM SETUP:END
19